Petites Annonces ICI
0 Membres et 1 Invité sur ce sujet
Regeneration while Driving Prerequisites (General):Ignition ON Engine ON (Idle) Coolant Temperature above 70 °C (see MVB 002.4) Particle Filter Load below Specification (see MVB 108.2/3, VCDS should give the specified values) If the Particle Filter Load is above Specification the Particle Filter needs to be replaced since the car may burn down when regenerating. Power Consumers ON (Light, Seat Heating, Front/Rear Window Heater, Climate Control) Engine Hood ClosedConditions (Driving Cycle):Vehicle Speed above 60 km/h (40 MPH) Engine Speed between 2000-2500 RPM (4th or 5th Gear, Automatic Transmission in Tiptronic) Duration approx. 10-15 Minutes Exhaust Gas Temperature before Turbo Charger above 170 °C (MVB 099.2) Exhaust Gas Temperature before Diesel Particle Filter above 150 °C (MVB 099.3) Exhaust Gas Temperature after Diesel Particle Filter above 150 °C (MVB 099.4) Drive the car based on the above Conditions until the Particle Filter Load is as low as possible (close to 0 %). In case the Regeneration fails there can either be problems with the Driving Cycle Conditions or with the Engine Hardware.